Messages

Subject:
Re: The process
Response To:
Re: The process ()

William Duffield
A design concept or two: You could instead leave the edge square, if you wanted, and remove material with a core box bit (or other profile) from the bottom edges of the two sides for hand holds. Cole jaws (or a Longworth chuck) will grip square profiles just as easily as round profiles. A square edge would leave you enough real estate to cut a slot to store the knife when you weren't actively chopping. You could instead inset a couple of rare earth magnets in the edge to hold the blade.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081