Messages

Subject:
Re: The process
Response To:
Re: The process ()

J Barrett Irby Jr
I mentioned in Bill's previous posts that I have done about 6 of these. I made up the blanks and cut it round on the bandsaw and sanded it flat with a drum sander, then mounted it in Cole jaws with a 3/4 spacer under one edge and turned it. Sometimes I dish the other side out slightly. Most of mine were end grain. I also turn a groove around the edge to form a handle.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081