Messages

Subject:
Re: What is acceptable Moisture content for Rosewo

John in NM
That is BS, except that if they are using an inductive meter without a correction chart dense woods will tend to read higher as I recall (but a caveat, that is a vague recollection from 20 years back). That could be what the wood vendor is saying.

13% isn't that bad though. Wouldn't do yet for a table top, but it should be past warping and checking. For something like table legs it would be ok to use at this point. In Reno it should finish drying quickly too.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081