Messages

Subject:
Re: CBN grinding wheel question

Derek Cohen (in Perth, Australia)
John, your choice is relevant to lathe chisels, however a flat woodworker would be better served with a 180 grit.

My ideal two-wheel set up for plane blades and bench chisels is a 180 grit on on side, and a linen buffing wheel on the other. The latter is to add a Unicorn profile to chisels. You should try this with lathe chisels as well - I am finding the very helpful.

Regards from Perth

Derek

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081