Messages

Subject:
Chamfer Bit question

Barry Irby
I failed to chamfer the front edge of the Console I am building for my son. (Who knew he had such an eye for detail?)

I think I need a chamfer bit that will cut a 60* bevel. I looked on Google and found one by Amana for about $106 and one form Yonico for about $15. Both have 1/2" shanks. I would rather have one with a 1/4" shank which may be a "miniature".

This is funny, I know Amana but would not want to pay that much for something I will use for about five minutes. OTOH, never heard of Yonico and am scared of a REALLY cheap bit. Too far into this project to start over. Any suggestions?

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081