Messages

Subject:
Re: Router Table Bit Problem

Stuart Johnson
The sliding dovetails were stopped not tapered using a 3/8 dovetail bit 3/16 inch deep. The dados were using 3/8 straight bit also 3/16 inch deep. I understand about using a straight bit first on the dovetail but at 3/16 I didn't see the need. I'm done with this part of my project now but will keep working on the issue until I find a solution.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081