Messages

Subject:
Yep
Response To:
Brass u-channel ()

JL
I could get the 1" channel which would have a 3/4" interior width. I could then saw it to length.
A bit thick at 1/8", but not too bad.
The 3/4" channel, I would have to chisel (or route) down to 1/2" thick lumber, which can be done.

I'm leaning towards the 1".

Ideally, I would like something w/ legs that are a bit longer - say 1.25" or greater - but this looks like the closest.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081