Messages

Subject:
Re: Planer keeps going out of adjustment

Keith Newton
If the hand wheel or crank stays where you locked it, then I'm with the PM guy. It may be a set screw in one of those parts is loose.

Why don't you try just putting a board in between the cutter and bed, then crank it up against it, and see if you can keep turning it. If you can look underneath while you do this, maybe you can tell where the turning quits.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081