Messages

Subject:
Wasteing away the half blinds *PIC*

Bill Tindall, E.Tn.

I overcut the pin board in a case piece where this joint doesn't show. Makes being rid of the waste easier.

I routed away most of the waste as usual, which for me means the orientation shown and not orthogonal, with the router on the end of the board. While some claim this other approach superior, in this case it would mean routing 7/8" deep. 1/4" bits can acquire worrisome vibrations at this depth of cut. In my case the cut is 9/16" deep. It all went smoothly, and only 7 more of these joints to go

Next will be cutting the sockets for the drawer dividers.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081