Messages

Subject:
Re: A source for Ceramic disks for bandsaw guides

Barry Irby
I don't know how hot they would get, but some epoxy is not rated for much heat. So, if you go this route, look for epoxy or glue that has a high temperature rating. One of the disks coming loose in the middle of a heavy cut might get exciting.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081