Messages

Subject:
Re: Straighten Clear Vinyl Tubing

Paul Blackwell
When I built a marble machine, the method of getting the marbles to the top of the contraption was clear vinyl tubing, and I had to bend it in two places to 90 degrees. The method they recommended was to heat the tubing in the oven (don't remember how hot) and bend it around a form. Worked fine, but had to be careful with the tubing closing up at the bend. Should work with straightening also.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081