Messages

Subject:
set up time ....
Response To:
Re: My bad, .... ()

Bill Tindall, E.Tn.
I will say again, this takes a lot longer to set up than to do

If you tell me how wide and deep the cove is to be, the following occurs:
Crank up blade to target height
measure width of projected blade
calculate cosine of the fraction
set fence to this angle
lower blade
push through first pass

I'll leave you to calculate how long these steps take. The point of the above post was to show how quick set up can be.

I demoed making a crown for the club in my shop. Including discussion, questions, passing around examples, etc it was an hour program

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081