Messages

Subject:
Derek....
Response To:
Re: I agree with Bill, ()

Barry Irby
The saw I have can run a blade up to 3" wide. I don't have the manual for it but apparently to go to a narrower blade I should install a different set of guides. I have some carter guides that go under the table but they cam't be sued with the wide Stellie blade. (I think)

I would like to know what blade your friend is running.

My saw still has the original motor Which has brushes, runs on 120 volts/15 amps and howls like a banshee. It is underpowered by modern standards, but is I can get it to cut straight and smooth that won't bother me much. I am not a production operation so a few extra minutes won't matter much.

I want to be able to go to the saw, set the fence, make a few cuts and walk away and not have to change the blade back and forth from cutting curves and bowl blanks.

Thanks for the help.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081