Messages

Subject:
If you go the router route...

David Yoho
Thought I'd mention should you rough out at bandsaw and then follow a master and trim with a router, a normal straight fluted flush trim bit may not do as well on the end grain as a spiral flush trim bit. I have one 2-inches long for these occasions that works like a hot knife through butter.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081