Messages

Subject:
Re: How would you cut this piece?

Dick Coers
First I put down meticulous layout lines, cut off the line on the bandsaw, then trimmed to the line with a pattern bit and straightedge with a router. That was the master. Then cut wide of the layout lines again on the other pieces, and then used the master to trim the next pieces all around with a pattern bit in the router.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081