Messages

Subject:
Re: At a guess...
Response To:
At a guess... ()

Ralph Lipeles
You can eliminate the explosive concerns by doing what I did when I made a dust/chip collector system using plastic pipe. I drilled 1/8" holes about every foot and a half. Next, I put a screw into each hole extending slightly into the inside of the pipe but not bottomed out. Then, I wrapped a strand of copper wire around each screw and finally attached the end of the wire to a known good ground.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081