Messages

Subject:
Re: Routing a slot question?
Response To:
Routing a slot question? ()

AZ in Colorado Springs
I cut dadoes and grooves using 1/8" steps. Especially with 1/4" diameter, any deeper and the bit breaks. You're right that the end if the bit dulls, but that's how it goes.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081