Messages

Subject:
Re: Routing a slot question?
Response To:
Routing a slot question? ()

Bruce, a MN Galoot
I cut all mortises with either 3/8” or 1/2” solid carbide, upcut, spiral bits. They will plunge full depth just fine, but my router will howl like a banshee if I try to move it forward. I cut all mortises, indeed all deep cuts, using the step method you describe.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081