Messages

Subject:
marking the cut lines
Response To:
hand saw ()

Bill Tindall, E.Tn.
Tilt the cone. provide a surface parallel to the plane it will set on. Use this surface (plane in geometry terms), a table top as an example, to mark the cut lines. Obviously you will have to rig "table tops" at the heights you need.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081