Messages

Subject:
Re: How to cut this
Response To:
How to cut this *PIC* ()

Barry Irby
I have a cheap laser level. It throws narrow line. You could tilt your cone and fasten it in position. Set the level up on some sort of stand the correct height and use it to draw a line around the cone. Any sort of laser pointer would work. Then you could cut an oval in a piece of plywood that would fit over the cone and support it level and make the cut with a multi-tool.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081