Messages

Subject:
agree again...

John in NM
When I upgraded my PM100 to a segmented cutter head if anything the load on the motor was reduced, based on the noise level (I didn't bother buying a clamp on ammeter to actually measure this).

I would expect the load vs. time to be roughly the same, but the peak loads when the long blade cuts to be smoothed out to more of a steady state load as each little blade cuts in sequence.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081