Messages

Subject:
Re: Plunge Routers.....uses of.....

Barry W. Larson
Hi Mark:

What sort of bit are you using to cut the 1/4" plate? I have a project in mind where I would like to mill slots in 1/8" or 3/16" plate and was about to go looking for somebody with a milling machine, but if one of my old beater routers would be up to the task I might consider trying it out.

Thanks,

Barry W. Larson
Calgary, Alberta, Canada eh!

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081