Messages

Subject:
Re: Delta 1172
Response To:
Delta 1172 ()

Larry Clinton At Frankfort, (Central) Indiana
I purchased a jig several years ago from either Rockler or Woodcraft in Indianapolis - can't remember the brand, as I recall it was in the $100 range new. I do remember it required quite a bit of rework to make it run true to the saw blade. Took me a few hours to modify it so the face of the jig was perfectly parallel to the blade. It has worked perfectly since then.

Adjustments are coarse, so does require setup and measuring with scrap, does hold fine after setting. Doubt there is much difference between brands, but maybe the older Delta's wouldn't require the rework I had to do to mine.

Messages In This Thread

Delta 1172
Re: Delta 1172
Re: Delta 1172
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081