Messages

Subject:
Re: Knife sharpening Question, sanding belt?

John McGaw
I use a cheap 1" Dremel with German blue zirconia belts. I believe that the finest I have at the moment is 120-grit but that is OK since it is used mostly for rough re-shaping of edges. I even have a leather stropping belt for it that uses stick abrasive but it hasn't been used for so long that I figure it might rip if it was put under tension.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081