Messages

Subject:
Re: Craftsman Table Saw - Guides

Jerry Nicholson
I bought a Delta miter gauge several years ago and it fit perfectly on my 1964 Craftsman table saw. A few minutes of sanding on the bar on the Delta tenoning jig made it fit the Craftsman too. Actually, I think most of the sanding just removed the paint.

Jerry

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081