Messages

Subject:
Re: question
Response To:
question ()

Mark Hennebury
Spoil-board is just a sacrificial fence, it could be a strip off MDF screwed onto the miter gauge after you have confirmed the correct angle. you just make a fresh cut so that you have a reference to line up you knife-scribe line to cut the miter. so its a one shot cut process no creeping up on the miter a bit at a time and checking it.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081