Messages

Subject:
Re: Dust collector woes
Response To:
Re: Dust collector woes ()

Don Evans
What you did depends of what size your collector is. Doing what you did COULD, depending on the manlyness of the collector slow your air movement at the machines.
A good piping system on any collector starts out with the finest dust producing machines furtherest from the collector. Largest dust particle producing machines, like a planer, closest to the collector. The piping main starts out smallest the further from the collector and increases in size the closer to the collect it gets. I have seen this conversation go on groups like this and most say put in 6" main. That just isn't the way it should be done.
My system does have a 6" main part way but 10' from collect increases to 8" pipe to start slowing the air flow so good separation takes place inside the collector (it's a cyclone, Onieda). The system works extremely well.
Don
Don

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081