Messages

Subject:
Re: DIY Zero Clearance Insert with Riving Knife

Rum
This looks more scalable.. but for a couple of one-offs I just used a small razor saw and cut down but sides of the slot and and drilled out the end of the hole to release the scrap. Worked fine and took maybe 3-4 minutes.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081