Messages

Subject:
Ripping angles question

David Higgins
I need to rip an angle on the edges of a small piece. My problem is I need the outside dimension (width) of the piece to remain unchanged after the rip. My saw is left-tilt.

Any tips on how to line this up?

I guess one alternative is to clamp the piece into a vertical fence jig.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081