Messages

Subject:
You can make some cuts with shallower depth
Response To:
Routing Free Hand ()

Keith Newton
Or you might hot glue a thin strip for the bearing to ride, then remove it for the final pass. However I’d just do it freehand. Clamp the board, asume a linebacker stance with the elbows in close to your sides, and shift your weight from one foot to the other.

Do the ends before you do the sides, which will take care of chip out at the far end.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081