Messages

Subject:
Re: OK, what advice on hole size and layout?

JL
It depends.
I have a full width tail vise in my work bench.

I drilled my holes every 4" or so down the sides of my bench.
I use "Bench dogs" from Lee Valley which require a 3/4" hole.
Lee Valley also has their "Wonder Dogs" - but I don't have those.

YMMV

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081