Messages

Subject:
Ditto

Bill Tindall, E.Tn.
I do as you do, using a cut off to set the corner registration of the piece being glued, and to check that the mitered trim is the correct angle for whatever the angle needs to be.....half of 90.3 degrees for example. I have never seen this procedure describe in detail anywhere. It is the only way I can get good miters.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081