Messages

Subject:
Re: Thanks everyone....
Response To:
Thanks everyone.... ()

William Duffield
You probably already know this, but it is worth mentioning, just in case. Do not try to seat the bit all the way at the bottom of the collet. That could keep the collet from tightening completely on the bit shank. After pushing it all the way down, pull it back away from the bottom of the shaft at least 1/16" before tightening the collet.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081