Messages

Subject:
Re: Reinforcing an edgebanding

jesse cloud
Good point on clamping difficulties.

When I do large curved pieces, I put the piece on a sheet of ply or osb and glue small blocks (cauls) near the edges. Then a couple of wedges between each block and the workpiece/wedgeband will apply good pressure. Just be sure to have lots of the cauls and wedges.

Good use for scraps.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081