Messages

Subject:
Turns
Response To:
Re: 5 inch pvc pipe ()

Mark Mandell - Gone Round In New Jersey
Make duct turns with a pair of 45° bends and a short piece of straight rather than a single 90° el. Look for a radius of the bend greater than the diameter of the pipe to minimize restriction.

Aluminum duct tape does a nice job of sealing joints while allowing access.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081