Messages

Subject:
Incra I-Box Jig - cutting depth

David Lykins
A couple of years ago I was making a watch box for a good friend of mine, my brother-in-law had gotten an Incra I-box-jig so I thought I'd try it on my watch box. Long story short, I was using wood that was about 3/4", however his I-box jig would NOT cut a depth of 3/4". Incra states that it will do up to 1" spacing on the joints, however I haven't been able to find anything on how deep of a cut you can make.

Any information is greatly appreciated.

Thanks!

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081