Messages

Subject:
Depends on which model

Dick Coers
But on the model I have, the infeed and outfeed tables only touch at the far edge. If you put a straightedge across the whole length, the bed is flat and then you have two points of contact on the ends of the table. Never could figure why they didn't have the bed and tables in one plane.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081