Messages

Subject:
Size Matters

Mark Mandell - Gone Round In New Jersey
The thicker the epoxy layer, the more and higher heat it will generate. Spread the mix out thin so that the reaction heat is dissipated over a wider area you'll have no issues with heat. Pour it into a hole that's a inch thick or more and you may get deformation and even fracturing in the set plastic. Put a low VP/BP solvent in to thin a thick pour and get ready for the boil-off and foam even when using slow hardeners.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081