Messages

Subject:
Why do you want to change it?
Response To:
Out feed table ()

Derek Cohen (in Perth, Australia)
I am going to replace my fixed out feed table on the table saw with a rolling work table.

Hi CJ

You have not said why you wish to change. There is a big advantage to retaining a fixed out feed table - the floor evenness is then never an intrusive factor. Unless you need space, I believe it is advisable to keep the table attached.

Unless you are working predominantly with sheet goods, then a large outfeed table is unnecessary. I work 99% with solid wood, have a contractor saw, and the out feed table is about 12" long. That is enough for my needs.

A rather poor photo ..

If I needed more out feed space, I would only need to do so temporarily, and could make do with rollers.

What is your requirement?

Regards from Perth

Derek

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081