Messages

Subject:
Re: Out feed table
Response To:
Out feed table ()

Mark Mandell - Gone Round In New Jersey
Make you table a hair lower than the saw top. Provide a way to secure the table to the saw to prevent roll-away and maintain registration with the saw slots. Cut your slots 1" wide by 1/2" deep but close off the far edge. Make 2 sticks of wood or HDPE 1" x 1/2" to the table's width that you can drop in or take out of the slots for a level work surface.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081