Messages

Subject:
Out feed table

CJ in MPLS
I am going to replace my fixed out feed table on the table saw with a rolling work table. I can made the table match the out feed table height, but that will require slots for the cut off sled and miter gauge. If I make the height of the table equal to the bottom of the miter slots, I won't need to cut up the top surface of the table, but things will tend to drop a bit on the out feed side.

Any thoughts you might share on the height?

CJ

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081