Looking for Something?

Subject:
Re: Lathe headstock spindle
Response To:
Lathe headstock spindle ()

jmohnike
>You can have one made at a local machine shop. Have them make it out of shelby tubeing, turned between centers (not in a chuck) and thread it the same way.

The 1 inch, that I have used in the past, has a 1/2" hole inside which you can have a MT2 fitting machined into it or have it done later. You can also but the MT2 reamers from KBC Tools and do it your self.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081