Looking for Something?

Subject:
Re: Craftsman 12" Woodturning Lathe Accessory

Marsh Pronneke
>Grady, If your lathe is a 80's model you might go to the sears site
http://www3.sears.com/ Take the model # of your lathe and input it into the site to go to the parts page for it. They may very well show the "speed reducer setup" in the replacment parts.
I know I went there to look up some information on a 60's model drill press, it showed the parts breakdown and the part numbers. Any thing that I needed for it was not available any more, but just as a refrence it was worth the look.
An as the other poster said I'm sure it was just a jack shaft afair is common.
Good luck Marsh

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081