Hand Tools

Subject:
Re: first hand cut tails

Derek Cohen (in Perth, Australia)
I have trouble cutting a knife wall in hard oak.

As Bill asked, where is the baseline?

I scribe the baseline lightly on the show side and deeply on the non-show side. Once the tails are sawn to the baseline, the baseline on the show side is deepened (either with a cutting gauge or a knife) inside the tails. This makes it easier to create a chisel wall. I use the widest possible chisel for this - narrow chisels run the risk of twisting on the base line and creating gaps. A wide chisel keeps it all coplanar. The cutting gauge or knife may be used to sever/clean the knife wall after chiseling.

Remember, when using a cutting gauge (either Japanese or wheel type), do not try to cut the line in one shot. Always do this progressively, in a few strokes, lightly at first, then with increasing pressure as the line deepens.

Regards from Perth

Derek

Messages In This Thread

first hand cut tails *PIC*
Re: first hand cut tails
Re: first hand cut tails
Re: first hand cut tails
Unsolicited suggestion
Success will be assured
Re: Success will be assured
are you missing a piece of essential equipment
Re: are you missing a piece of essential equipment
Re: are you missing a piece of essential equipment
Re: are you missing a piece of essential equipment
Kirby is how I started
Re: are you missing a piece of essential equipment
Advice, praise and learning curves
Re: Advice, praise and learning curves
Re: Advice, praise and learning curves
Re: Advice, praise and learning curves
Re: Advice, praise and learning curves
Re: Advice, praise and learning curves
Art, fine art, and utter messes....
I agree with what you say...however....
Re: Art, fine art, and utter messes....
Re: Peter Follansbee... *LINK*
You missed the point
Re: You missed the point
Beauty is as beauty does (in my case)
Re: Beauty is as beauty does (in my case)
my experience with the schools..
Re: Beauty is as beauty does (in my case)
Flawed
Re: Flawed
I don't buy it...
Re: I don't buy it...
My situation was unique I think...
Is there a psychologist in the house?
The outer frame; the border. *NM*
Thanks for playing, Wiley :) *NM*
I don't think it matters...
The kids...
Re: The kids...
Re: Is there a psychologist in the house?
I'm waiting for...
Correct.
Where to start a 1000 piece jigsaw puzzle...
Where do you start a 1000-piece puzzle?
Re: Flawed
said better than I did *NM*
Re: Flawed
Re: Unsolicited suggestion
Re: Unsolicited suggestion
Re: Unsolicited suggestion
Re: Unsolicited suggestion
Re: Unsolicited suggestion--Stud Mills?
Re: Unsolicited suggestion--Stud Mills?
Re: Unsolicited suggestion
I don't do a lot of dovetails...
You provided some sage advice *PIC*
Re: I don't do a lot of dovetails...
yeah...
Re: Form Follows Catches :D
Skew chisel *PIC*
Re: Skew chisel
I did my first ones in oak... *PIC*
just read bill's later post..
Re: I did my first ones in oak...
Re: I did my first ones in oak...
Slicks and makers
Re: Slicks and makers *PIC*
Re: Slicks and makers
Slicks and makers
Re: Slicks and makers
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081