Hand Tools

Subject:
Re: Drawers -heads or tails

Derek Cohen (in Perth, Australia)
No problem, Jack. I misread Bill’s original post and in my twisted mind imagined that he was nailing the tail to the pin board! :D

Shooting a pin into a soft drawer side - even I am not that nutso to use hardwood for sides! - is doable. My current cabinet has 10 drawers, but I will size each one individually. I am on annual leave, cannot travel, and just chilling out in the shop (between visiting friends and small outings with my wife). I am not in a hurry. I try and enjoy my woodworking and, as much as I seek efficiency, I also avoid production mode or thinking.

Regards from Perth

Derek

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081