Hand Tools

Subject:
I can't get reasonable profile pictures....

David Weaver
and the test is over, and all edges were sharpened off at some point.

I'm writing in the document that I'm sure that the V11 can be accommodated ,but I didn't explore that for the scope of this test.

I did intentionally buff it twice as long, and in the guide, I gave i twice as many strokes on the flat bevels on diamonds to get to the same point. If you just buff it for five seconds, not much is done to it -it even still retains a bit of wire edge. Doubled, and the visual result is the same.

But as you've proved, it could be accommodated.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081