Hand Tools

Subject:
Re: Flat panel doors with beads...

Derek Cohen (in Perth, Australia)
David, no doubt you do not need advice here, so I add this to contribute to the discussion.

I’ve done quite a few of these types of doors. This was the first time I posted a build (not flat panel, however) ....

http://www.inthewoodshop.com/Furniture/Buildtheframe.html

Sean Hughto also wrote a nice pictorial making similar doors: http://www.inthewoodshop.com/Furniture/Making%20a%20frame%20and%20panel%20door.html

Since then I have coped the corners as Bill describes, rather than just mitering them as above. Having said that, the mitres have remained tight over the years.

Regards from Perth

Derek

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081