Hand Tools

Subject:
Re: Removing twist
Response To:
Removing twist ()

Derek Cohen (in Perth, Australia)
It is 14" wide by 37" long and just over an inch thick. It is twisted such that with three corners on the bench, the 4th corner is about a half inch off the bench. The finished piece is supposed to be 7/8 thick, but it would probably be ok down to about 3/4.

Jason, if you can determine roughly where the twist begins, I would rip away that section a little way in from that point. I would not rip at the halfway point.

This will afford you the maximum thickness for each section. The twisted section can be jointed to lie flat against the wide section. There should be minimal change in grain on the face side - essentially just a saw kerf and jointing removed (the other side may have lost a 1/4" - 1/2").

Regards from Perth

Derek

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081