Hand Tools

Subject:
question
Response To:
A small experiment ()

Bill Tindall, E.Tn.
Do I understand your clever means of setting the cap iron? The paper prevents the cap iron from penetrating the thickness, while the blade slices through and stops at .....something? If so it seems like the cap iron edge is going to compress the paper somewhat and the blade is going to penetrate whatever stops it but good fortune would result in these errors being equivalent.

Did you see any visual difference in the surface from planing uphill vs down hill?

What does the surface of the stringing section look like that I suppose was planed orthogonal to the grain direction?

When we made Federal legs with Steve Latta we used white glue and the inlay and string were scraped shortly after installation. When scraping the cross banded string the scraper leveled it at and angle such that we were not scraping across the grain. The result was not favorable scraping across the grain.

Having proven it can be done in this situation what advantage did you find of plane over scraping?

Messages In This Thread

Heat balance at plane blade tip
Re: Heat balance at plane blade tip
Re: Heat balance at plane blade tip
Re: Heat balance at plane blade tip
Re: Heat balance at plane blade tip
Re: Heat balance at plane blade tip
Re: Heat balance at plane blade tip
K&K SEM pictures
Re: K&K SEM pictures—here they are *LINK*
Re: K&K SEM pictures—here they are
Re: K&K SEM pictures
Re: K&K SEM pictures *LINK*
Re: K&K SEM pictures
The data shown above
Re: The data shown above
Re: The data shown above
Re: The data shown above
Re: Agree on three points
Question about setting blade exposure
Re: Question about setting blade exposure
Re: Question about setting blade exposure
Re: Question about setting blade exposure
Is planing the way to level this surface
Toothing planes
Gosh...
Re: Gosh...
Re: Gosh...
Re: Is planing the way to level this surface
Re: Question about setting blade exposure
Re: Question about setting blade exposure *PIC*
summary?
Re: summary?
Re: Question about setting blade exposure
A small experiment
Re: A small experiment
question
Re: question
clever setting procedure; blurring? *PIC*
Re: clever setting procedure; blurring?
Holly inlay properties
Divergence from the classic
Re: A small experiment
Re: A small experiment
Re: totes etc.
Re: Handle shaping method and tools... *LINK*
Re: A small experiment
Re: A small experiment
I used to get fired up...
The whole translation/review—for the obsessed *LINK*
Re: The whole translation/review—for the obsesse
Re: The whole translation/review—for the obsesse
Re: The whole translation/review—for the obsesse
Where is this going?
The purpose of the original test...
Re: The purpose of the original test...
What's allowed on forums?
you underestimate the interest
Re: you underestimate the interest
bored to tears ?
Re: bored to tears ?
There is one thing remaining..
My suspicion...
Re: My suspicion...
Re: My suspicion...
Another table from SB
Yes - the confusion without XHP
Odd thing about CTS-XHP wear resistance
All metal wear not equal
Re: This isn't Instagram
Re: This isn't Instagram
Re: The whole translation/review—for the obsesse
Re: not quite, but find what you like...
David - keep at it
Re: David - keep at it
Re: David - keep at it
I don't understand social media
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081