Hand Tools

Subject:
Re: Duration by Abrasive 2 - 30 degrees

David Weaver
I would trust these results over those on the Norris plane. It's easier to just be the power source for this plane than it is with the Norris, which takes a little more influence from the user.

Given the small difference in both cases, I'd be more apt to say that in a range of 10 to 15 degree clearances, the edge finish matters more than the clearance.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081